How to Use Hall Effect Joystick for PS5 Controller
By Hyperkin Store / Let's Game! – HyperkinStore | Published: 2026-10-18
Category: How-to Guides
Learn how to install a hall effect joystick on your PS5 controller to fix drift and improve durability with our step-by-step guide.
Quick Answer
Installing a hall effect joystick in your PS5 controller is a straightforward DIY fix that eliminates stick drift and extends the controller's lifespan. You'll need basic soldering skills and about 30 minutes.
Why Hall Effect Joysticks Beat Standard Ones
Standard PS5 joysticks use physical contacts that wear down over time, causing drift and dead zones. Hall effect joysticks use magnetic sensors with no physical contact, rated for over 5 million rotations. This makes them virtually immune to the wear that causes drift.
What You'll Need Before Starting
You'll need a soldering iron, solder, flux, a small Phillips screwdriver, a plastic spudger or pry tool, tweezers, and the hall effect joystick module. The Hyperkin Hall Effect Joystick for PS5 – 2pk is a direct replacement designed for PS5 controllers, so you won't need to modify the board.
Step-by-Step Installation Guide
- Disassemble the Controller: Remove the four back screws with a Phillips screwdriver. Gently pry open the shell using a spudger, starting from the bottom edge. Lift the back cover off and disconnect the battery connector by pulling the ribbon cable upward. Common mistake: pulling the battery cable by the wires instead of the connector can damage it. Always grip the connector itself.
- Remove the Old Joystick Module: Unplug the ribbon cables connecting the joystick board to the main board. Desolder the three pins for each axis (X, Y, and ground) on the joystick module. Use a solder sucker or wick to clean the holes. Carefully lift the old module out. Checkpoint: ensure all solder is removed from the holes before pulling the module; otherwise, you may lift the pads.
- Install the Hall Effect Joystick: Insert the new Hyperkin hall effect joystick module into the holes, aligning the pins. Solder each pin securely, ensuring no bridges between adjacent pins. Reconnect the ribbon cables. Common mistake: applying too much heat can damage the hall effect sensor. Solder each joint in under 3 seconds.
- Reassemble and Test: Reconnect the battery, close the shell, and tighten the screws. Power on the PS5 and go to Settings > Accessories > Controllers > Test Input. Move the joystick in all directions to verify full range and no drift. Checkpoint: if the joystick calibration seems off, reset the controller using the small button on the back near the L2 trigger.
Product Used in This Guide
- Hall Effect Joystick for PS5® – 2pk: Drift-free technology for accurate control rated for over 5 million rotations This means your controller should stay drift-free much longer than stock joysticks, saving you from frequent replacements.
Hall Effect Joystick for PS5® – 2pk
